Wiring Notes - Dank Light EZ-Connect DIY Grow Light Kit Assembly Instructions Manual

B. Since 2 Drivers are required to run the entire fixture, its best to think about wiring the
light fixture in 2 halves, with half the lightstrips (3 or 4 depending on whether you are
building the 8 or 6 lightbar kit) being wired on the left side of the fixture and the other half
of the lightstrips being wired on the right side of the fixture.
C. The lightstrips from the left half of the fixture are then wired to first Driver and the
lightstrips from the Right half of the fixture are wired to the second driver.

WIRING NOTES:

● We highly recommend you take steps to route your wiring through the channels in the
EZ-Connect Frame and Driver mount extrusion as much as possible. It will both clean up
your build and reduce the number of wires in your grow which could get caught or
snagged causing wiring problems for your light.
● We also recommend the use of Zip Ties to secure the wiring to Frame or Driver Mount
extrusion.