Dank Light EZ-Connect DIY Grow Light Kit Assembly Instructions Manual page 14

D. To begin wiring your EZ-Connect lightbars, find the bags marked, "Lightstrip Input Wires"
and "Solderless Wire Connectors and Dimmer".
Parallel Driver Lightstrip Wiring Instructions
A. Begin by finding the longest set of wires in the bag, followed by the second, third
and fourth longest.
B. The longest sets of wires are used on the outermost lightbars (those furthest
from the middle of the fixture). The second longest set is used on the lightbars
that are the second farthest from the middle of the fixture and so on.
C. Connect the Red wires to the + terminal of the LED lightstrip and the Black wires
to the - terminal of the LED Lightstrips. Keep connecting input wires until all wires
have been connected to your lightstrips.
D. When all wires have been connected to your lighstrips run the Red (+) wires from
either the left or right half of your fixture to a single 5 terminal Wago Solderless
Connector and run the Black (-) wires from the same set of lightstrips to
another single 5 terminal Wago Solderless connector.
-- Repeat the same steps for the lightstrips from the other half of your fixture.
IMPORTANT NOTE: Please reference the Parallel Driver Wiring Instructions diagram
above to see how the wiring is completed if you are unsure.