Dank Light EZ-Connect DIY Grow Light Kit Assembly Instructions Manual page 24

Series Driver Wiring Instructions
a. Find the Output Section of a SINGLE driver and locate the single large Black wire with
the 2 smaller V+ and V- wires protruding from it.
b. Grab the 2 terminal Wago Solderless Connectors you previously wired to the Red (+)
wires of a set of SERIES WIRED lighstrips and connect the open terminal on the Wago
to the V+ Output wire from a Single Driver.
c. Grab the 2 terminal Wago Solderless Connectors you previously wired to the Black (-)
wires fromTHE SAME SET OF SERIES WIRED lightstrips and connect the open
terminal on the Wago to the V- Output wire from the same driver .