Advertisement
Pub# OM22-iScan EC-OM
SoilViewer OM System Check
Select OM from the Sensor Checks drop down menu.
Figure 5
After clicking the button the following will appear:
Figure 6
Make sure the window is clean and in good condition. (see below) Place the dark side of the reference
block under the window, and click continue. Then the next message will appear.
Figure 7
Flip the reference block over to the light side and place under the window, and click continue. Then this
message will appear:
or
Figure 9
The reference values have been stored, and the system is ready for mapping.
4-4
Advertisement
