Advertisement
iScan Installation Instructions—toolbar mounting
Step 1. Determine toolbar location.
12" (30 cm) of open toolbar space is
needed with no obstructions around the
mounting location. Ideally this is near the
middle of the toolbar but can be near the
outside end if that is only location with
adequate clearance.
Step 2. Install mounting bracket.
Using supplied U-bolts, attach bracket
to toolbar and tighten nuts securely.
Position bracket centered between any
existing implement row units. Be careful
not to pinch any existing cables or
hoses. Reroute these as needed.
Step 3. Lower iScan module
onto mounting bracket.
Attach chain or straps to lift point,
raise iScan using loader or forklift,
and carefully move module
between row units. Position iScan
mounting plate above mounting
bracket on toolbar and lower onto
mounting bracket. Bracket has
centering tabs that self-align the
two pieces together for easy bolt
installation.
Figure 3
Figure 4.
Toolbar
mounting
bracket
Module
mounting
Figure 5.
plate
Stand clear to avoid injury
3-2
Pub# OM22-iScan EC-OM
Lift point
Advertisement
