IBM 9009-41A Manual page 59
Pcie adapters
Hide thumbs
Also See for 9009-41A:
- Manual (194 pages) ,
- Site and hardware planning (164 pages) ,
- Instructions manual (32 pages)
Table of Contents
Advertisement
Attention: Operating the system without the service access cover on for more than 10
minutes when the system power is turned on might damage the system components.
a. Release the service cover latch by pushing the release latch (A) in the direction shown.
b. Slide the cover (B) off the system unit. When the front of the service access cover clears the upper
frame ledge, lift the cover up and off the system unit.
Figure 32. Removing the service access cover from a rack-mounted system
For a stand-alone system, complete the following steps. Refer to Figure 33 on page 46.
Attention: Operating the system without the service access cover on for more than 10
minutes when the system power is turned on might damage the system components.
a. Release the latch by pushing the release latch (A) in the direction shown.
b. Slide the cover (B) off the system unit. When the front of the service access cover has cleared the
upper frame ledge, lift the cover up and off the system unit.
Installing, removing, and replacing PCIe adapters for the 9009-41A, 9009-42A, and 9223-42H system 45
Advertisement
Table of Contents
