IBM 9009-41A Manual page 40

Figure 21. Closing the cable management arm
11. Close the rack door at the rear of the system.
12. Choose from the following options:
• If you completed this procedure with the system power turned off, continue with step "13" on page
26.
• If you are using the AIX operating system, continue with step "14" on page 26.
• If you are using the IBM i operating system, continue with step "15" on page 27.
• If you are using the Linux operating system, continue with step "19" on page 27.
13. If the system power is turned off, complete the following steps:
a) Start the system. For instructions, see Starting a system (www.ibm.com/support/
knowledgecenter/POWER9/p9haj/crustartsys.htm).
b) Continue with step "20" on page 27.
14. If you are using the AIX operating system, you must configure the adapter by completing the
following steps:
a) Install the AIX device drivers for the installed adapter.
For instructions, see Installing the AIX device driver software.
b) On the console, enter cfgmgr to configure the adapter.
c) Continue with step "20" on page 27.
26 Power Systems: PCIe adapters for the 9009-41A, 9009-42A, or 9223-42H