SOMFY inteo LIGHTING indoor RTS Installation Manual
SOMFY inteo LIGHTING indoor RTS Installation Manual

SOMFY inteo LIGHTING indoor RTS Installation Manual

Advertisement

Quick Links

INSTALLATION

1

Characteristics

80 mm
2
Installation
Recessed mounting :
Surface mounting :
3

Programming and operating

3.1 Record the first control

1
Set the LIGHTING indoor RTS in its programming mode :
PROG
,S, ,S
2 s
Press for more than 2 seconds on the programming button of
the LIGHTING indoor RTS.
The LED of the LIGHTING indoor RTS lights on and the
lamp lights for 2 secs.
The LIGHTING indoor RTS is in programming mode for one
minute.
inteo
The LIGHTING indoor RTS is a radio receiver dedicated to control an incandescent or
halogen lamp with an RT or RTS control (no lamp with gear).
Up to twelve different controls can be memorized in the memory of the LIGHTING
indoor RTS allowing individual, group and master commands.
This device must be installed and programmed by qualified installers for whom
this instruction is intended.
programming
button
manual
control button
fuse
45 mm
ø 60
60
PROG
,S, ,S
R
R
LIGHTING indoor RTS
PROG
LED
,S, ,S
R
Recommandation of mounting for better radio
reception :
minimum distance between LIGHTING indoor RTS
and the floor : 1,5 m.
minimum distance between a LIGHTING indoor
RTS and a radio transmitter : 30 cm.
minimum distance between two LIGHTING indoor
RTS : 20 cm.
Warning : cordless radio equipment (e.g.
headphones) in 433MHz can affect the fun-
ctionning of the LIGHTING indoor RTS.
2
Record the first control :
or
0,5 s
2 s
RTS control : press briefly the "prog" button.
RT control : remove the battery, press briefly the button, replace the batte-
ry and press again briefly the button.
The lamp lights during 2 secs. again and the LED of the LIGHTING
indoor RTS blinks during 5 sec. The control has been recorded.
guide
Main supply : 220-240V
Fuse : 3,15A
Class II product
Protection index : IP30
Load : incandescent or halogen
lamps 500 W max.
Radio frequency : 433.42 MHz
Operating temp. : +5°C to +40°C
Hereby, SOMFY, declares that this equipment is in com-
pliance with the essential requirements and other rele-
vant provisions of Directive 1999/5/EC.
A Declaration of Conformity is available at the web
address www.somfy.com Heading CE
N
L
POWER
SUPPLY
Phase
Neutral
0,5 s
0,5 s
~
L
Phase
N
Neutral
Output
X
Do not use
PROG
5 s
,S, ,S
R
2 s

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the inteo LIGHTING indoor RTS and is the answer not in the manual?

Questions and answers

Summary of Contents for SOMFY inteo LIGHTING indoor RTS

  • Page 1 80 mm Operating temp. : +5°C to +40°C 45 mm Hereby, SOMFY, declares that this equipment is in com- pliance with the essential requirements and other rele- vant provisions of Directive 1999/5/EC. A Declaration of Conformity is available at the web address www.somfy.com Heading CE...
  • Page 2 Check that the transmitter has been properly recorded in the LIGHTING indoor RTS memory (section 3). Check for any other possible source of radio interferences. Lost in your programming mode: Just make a complete reset and start again. SOMFY SAS, capital 20.000.000 Euros, RCS Bonneville 303.970.230 All rights reserved to makes changes without prior notice.

Table of Contents