PUTCO 85165 Installation Instructions

PUTCO 85165 Installation Instructions

Bumper grille for ford super duty

Advertisement

2011+ FORD SD Bumper Grille Installation Instructions
Please read all instructions before installation and to check to see that all parts are included.

KIT CONTENTS:

Description
Bumper Grille
Alcohol Wipe
Only for Lighted Grille (below)
Light Bar (Installed)
Wiring Harness
Switch
Light Bar Installation Instructions

Bumper Grille Installation

1. Remove bumper grille from packaging. Check to see if all parts from above table are included.
2. Remove factory license plate by unhooking the bottom hooks first. Then squeeze the top two clips
to release the license plate from the bumper.
3. From under the vehicle, remove the three plastic clips that hold the rubber flap to the bumper.
Ensure you do not break the plastic clips as you will need them to reinstall the flap when finished.
This will allow for easier installation of the bumper grille later. Fold the flap out of the way. See
Figure 1.
Qty.
1
1
1 or 2
1
1
1
Plastic clips removed
from bumper.
85165, 86165, 87165, 88165
87165L, 88165L
87165L-2, 88165L-2
Figure 1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 85165 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for PUTCO 85165

  • Page 1 85165, 86165, 87165, 88165 87165L, 88165L 87165L-2, 88165L-2 2011+ FORD SD Bumper Grille Installation Instructions Please read all instructions before installation and to check to see that all parts are included. KIT CONTENTS: Description Qty. Bumper Grille Alcohol Wipe Only for Lighted Grille (below)
  • Page 2 85165, 86165, 87165, 88165 87165L, 88165L 87165L-2, 88165L-2 4. Using the provided alcohol wipe, wipe down all areas that the bumper grille adheres to the Bumper. Refer to Figure 2. Figure 2 Clean area behind bumper as shown. 5. Insert the grille into the bumper starting with the bottom of the grille first. Refer to Figure 3 for...
  • Page 3 85165, 86165, 87165, 88165 87165L, 88165L 87165L-2, 88165L-2 6. Rotate the grille upwards inserting the two tabs into the holes for the factory license plate. See Figure 4. Figure 4 7. Once the tabs are in the license plate holes, place the upper tabs behind the bumper while rolling the grille into place.

This manual is also suitable for:

86165871658816587165l88165l87165l-2 ... Show all

Table of Contents