Electrical Connection - PizzaMaster 350 Series Owner's Manual

Electrical connection

Electrical connection
For connection and correct fuse rating, see the
oven rating plate, the table for fuse protection need
and the attached electrical diagram.
After reading all above information, follow instructions
below for correct electrical connection.
The earth potential equalizer screw has to be installed.
The earth potential equalizer screw is located on the
backside next to the connecting cable.
1. Make sure electrical supply cor-
responds with that specified on the
oven rating plate
Remove the screws that secures the
right-hand side panel, and take off
the panel to access to the electrical
components.
6
Electrical Connection
2. The oven can be connected with
1 power supply per deck or 1 power
supply per oven, this depend of the
voltage and oven model.
PizzaMaster®
Important!
For reasons of safety and the validity of the war-
ranty, all electrical work must be carried out by a
qualified electrician.
The oven must be connected via an external
main switch with min. 3 mm gape of at least 3
mm for each power supply cable.
3. For Cable connections or cable
replacement:
Open the righ hand panel. Follow-
ing the appropriate electrical wiring
diagram confirming to the oven rat-
ing plate, connect the power supply
leads to the field terminal block.
Make sure all connections are tight,
then place back the right-hand side
panel.