Electrical Connection; Positioning The Oven; First-Time Start-Up Of Oven - PizzaMaster PM 351ED Instructions For Installation, Use And Maintenance Manual

Electrical connection

Important!
For reasons of safety and the validity of the war-
ranty, all electrical work must be carried out by a
qualified electrician.
The oven must be connected via an external main
switch with min. 3 mm gape of at least 3 mm for
each power supply cable.
Power and fuse ratings per oven
Modell 230V 1N
50/60HZ
PM 351ED 10A
PM 351ED-1 16A
PM 352ED 20A*
PM 352ED-1 25A*
PM 352ED-2 32A*
PM 401ED 16A
PM 401ED-1 20A*
PM 402ED 32A*
PM 402ED-1 40A*
PM 402ED-2 40A*
PM 451ED 16A
PM 451ED-1 25A*
PM 452ED 32A*
PM 452ED-1 40A*
PM 452ED-2 -

Positioning the oven

When positioning your oven, it is important to consider
the following points:
• It is important for the floor to be flat, so that the oven
is both horizontal and stable.
• For ventilation of the oven, a space of at least
50 mm is needed between the oven and any
adjacent wall, on all sides.
Connection / Positioning / First-time start-up
400V 3N
50/60HZ
3/10A
3/10A
Before connecting the oven see the ovens rating plate
3/10A
and attached electrical diagram
3/10A
3/10A
The oven has to be connected with the attached power
supply cable (1.5 m)
3/10A
3/10A
* Model not provided with a power supply cable
3/16A
3/16A
The earth potential equalizer screw has to be installed.
3/16A
The earth potential screw is located on the backside
3/10A
next to the connecting cable.
3/10A
3/16A
3/16A
3/16A

First-time start-up of oven

Before putting the oven into operation, it should be
switched on and brought up to temperature to burn off
any remaining protective oil in the oven chamber(s).
When this is done, the oven will emit a certain amount
of smoke, which is normal. Make sure therefore that the
kitchen ventilation system is switched on. If possible,
open doors and windows to allow the smoke to escape
more quickly. All decks can be switched on simultane-
ously. Follow the running-in schedule below:
1. Close all the oven doors.
2. Switch on the oven and set all heat controls to posi-
3. When the oven reaches 300
4. The oven is now ready for use.
tion 10 and adjust the thermostat to 300
20 minutes), leave it switched on for 1 hour.
o
C.
o
C (which takes about
5