Table of Contents
Advertisement
Status codes
Status code
130 CONNECTION
TIMEOUT
250 OK
500 INVALID VALUE
501 INVALID PARAMETR
502 UNKNOWN
COMMAND
505 FORBIDDEN
510 OUT OF RANGE
For more information about the Telnet protocol, visit the Support >
Download section of our website and see the following document:
Telnet - description of NETIO M2M API interface - PDF
Description
No command submitted for longer than 60
seconds.
The Telnet connection is terminated.
The command is accepted.
The command parameter is not valid.
The command parameter is not valid.
The command is not valid.
An attempt to make an action with not
sufficient permission (i.e.: control output with
read only user, try to monitor output state with
non-logged user, where ReadOnly user is
password protected etc.)
Specified value is not valid (i.e. trying to control
port 4 on device, which has only 1 socket)
67
Advertisement
Table of Contents
