Netio PowerCable 101 Series Manual page 65

Telnet connection to a PowerCable device IP address and its Telnet port
When the connection is established, the PowerCable device returns the following response and is
ready to receive commands.
Telnet welcome message
100 HELLO B166A626 - KSHELL V2.0
Note: The Telnet connection is automatically terminated after 60 seconds of inactivity. It is possible
to use the noop command to keep the connection alive for the next 60 seconds.
Command set
Command
login <username>
<password>
quit
noop
port list
port <output> <action>
Each command must be followed by CR and LF characters (hexadecimal 0D and 0A). Typically, you
can use Enter in the terminal.
Description
Log in a user.
Replace <username> and <password> by the
equvalent attributes defined in the Telnet
protocol configuration (Figure 42)
<password>
Example – log in with username netio and
password passwd:
login netio passwd
Log out and terminate Telnet connection.
Keep the Telnet connection alive for the next
60 seconds.
No-operation
Returns state of output.
port list
250 1
(output is ON)
Control the output.
<output> is replaced by the output number (1)
<action> is replaced by a parameter described
below
If no <action> is provided, the state of the
output is returned.
65