Table of Contents
Advertisement
Energy in watt-hours (Wh / kWh) is the cumulative energy consumed over a time interval. The
value is the total consumption at the output since the last reset of the counter.
By default, the cumulative energy consumption is counted from the time the PowerCable was first
powered on. To reset the counter, go to the Settings > System tab and click the Reset Power
consumption counter button (see Figure 27). This restarts the measurements as of the current
moment.
Voltage in volts [V].
Frequency in hertz [Hz].
6.1.2
Outputs - General
Click the picture of the output to open detailed settings.
The
General tab configures basic parameters for controlling the output.
Figure 26 – General output configuration
Output name is shown above the two control buttons to improve clarity.
Short ON/OFF delay is an integer specifying, in milliseconds, the duration for the Short OFF (power
cycling) and Short ON actions.
During this interval, any attempts to switch the output state via M2M API protocols are ignored.
Output PowerUp state defines the state of the output whenever the device is powered up or
restarted. The output can be switched on (ON), switched off (OFF), or set to the last state before
the restart (LAST).
Click Save Changes to save the settings.
To close the configuration dialog, click the
symbol in the top right corner.
27
Advertisement
Table of Contents
