Initial Setup; Micro Sd Card Requirements - Fire Cam Onyx User Manual

Using Fire Cam Onyx Underwater
Put some silicon grease on the rubber O-rings from time to time, especially
before using underwater. Make sure the rear cap ③ is closed tight. Using
waterproof cap will not allow audio recording.
Initial Set Up
Unscrew the rear audio cap
OFF before adding or removing the micro SD memory card. Insert the card, label facing
down, into rear card slot
⑤. Shut camera power off and
camera
when battery is fully charged. If charging through PC, shut camera off after connection.
LED will remain green while charging.
time averages around 60-75 minutes in 4k and 1080-120fps; 120 minutes in 1080-60fps or
30fps on a fully charged battery.

Micro SD Card Requirements

The camera will only operate a FAT32 formatted micro SD memory card, up to 128GB. A
minimum speed of Class 10 / U1 is required. Upon start up, the camera will automatically
convert 64gb and 128gb exFAT cards to the FAT32 format.
DO NOT store any other data on the micro SD memory card being used in the camera.
Memory cards should be formatted for trouble free performance of the camera on first use
and after transferring video files. All data will be erased when formatting so make sure all
important video files are transferred first.
Fire Cam recommends SD Card Formatter at:
https://www.sdcard.org/downloads/formatter_4/
③.
Insert battery into battery slot
⑥
until it clicks to hold it. Plug the USB cable and charger to the
LED ① is green while charging. It will go off
Allow at least 4 hours on first charge. Recording
⑦.
Make sure camera is