Installing/Removing Battery - Fire Cam Onyx User Manual

Installing/Removing Battery

The battery is designed to have a very tight fix to maximize reliability in high vibration
activities. To remove the battery, pull it out with a firm grip.
Power on/off Your Fire Cam Onyx
Turn Fire Cam Onyx On
Turn Fire Cam Onyx Off
* If no micro SD card is installed, the LED will flash red and blue.
* If battery is not charged, camera will turn on and shut off immediately.
* Format micro SD memory card if LED remains a solid light after power on.
!
Turn on the Fire Cam Onyx by pressing the Power/
Shutter button ② until the blue LED turns on. The camera
will vibrate once long. After releasing the button the red
LED will flash and beep and start recording. LED will
continue to flash red while recording. Press Power/
Shutter button again to stop recording and enter stand by
mode.
Turn the Fire Cam Onyx off by pressing the Power/
Shutter button ② in standby mode until the red LED
flashes. The Fire Cam Onyx will short vibrate twice and
beep 6 times and will switch off.
Estimated Storage Chart