Initial Set Up - Fire Cam OPTIMAX User Manual

Initial Set Up

1. Open the Battery Cover located at the top of the OptiMax ⑨.
Insert Battery, aligning contacts. Battery will be flush with OptiMax.
Use two thumbs to evenly close hatch. It will be very tight against
waterproof seal but will latch with even pressure.
2. Make sure the OptiMax is OFF before adding or removing the
memory card. Install a micro SD memory card (minimum speed
Class 10/U1, up to 128GB) into the rear slot. To insert the micro SD
card, slide the micro SD card into the card slot on the back of the
OptiMax with the card label facing to the front of camera. The micro
SD card will click into place once it is inserted past flush with the
OptiMax. Use your fingernail to do this.
3. Memory card should be formatted for trouble free performance on
first use and after transferring video files. All data will be erased
when formatting so make sure all important video files are
transferred first. Fire Cam recommends SD Card Formatter at:
https://www.sdcard.org/downloads/formatter_4/
4. When using a micro SD memory card in the OptiMax, there must
be NO data from other devices on the card.
*Always try formatting the memory card first if there are any issues
in startup of the camera.
*If no micro SD memory is inserted in the OptiMax, the LED on top
of the camera will blink red when turned on.