Sony BKNW-26 Installation Manual page 5

5. Remove the adhesive tape from the DP-265/265A
board.
6. Disconnect the harnesses from the DP-265/265A
board, and then unfasten them from the lead pin.
For the DP-265 board
Disconnect the harnesses from CN5, CN6 and CN1.
CN5
For the DP-265A board
Disconnect the harnesses from CN5, CN6, CN10,
CN11 and CN12.
CN5
CN11
BKNW-26
Lead pin
CN1
CN6 Tape
DP-265 board
Lead pin
CN12
CN10
Tape
CN6
DP-265A board
7. Disconnect the DP-265/265A board by lifting it from
the CN-1541 board.
m
. When the shield plate (B) is attached, slide it in the
arrow direction.
. When the DP shield case is attached, remove it also.
CN7
DP shield case *
CN-1541 board
Shield plate (B) *
* : The parts marked by an asterisk are not used in the
units of 910 lot or later.
n
Improvement have eliminated reattaching some parts.
* * * * * in illustrations (up to 910 lot)
Shielding plate (A) assembly
Shield wire
Screw (PS3 x 10)
Shield plate
Bonding wire
DP shield case
1-3. Installation Procedures
DP-265/265A board
Re-attachment
Not required
Not required
Required
Required
Required
Required
1-3 (E)