Graco EM5 Series Instructions And Parts List page 2

Table of Contents
Warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Service . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Parts List . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Parts Drawing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Technical Data . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Dimensional Drawing . . . . . . . . . . . . . . . . . . . . . . . . . .
Graco Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Graco Phone Number . . . . . . . . . . . . . . . . . . . . . . . . . .
EQUIPMENT MISUSE HAZARD
Equipment misuse can cause the equipment to rupture or malfunction and result in serious injury.
This equipment is for professional use only.
Read all instruction manuals, tags, and labels before you operate this equipment.
Use the equipment only for its intended purpose. If you are not sure, call your Graco distributor.
Do not alter or modify this equipment.
Check equipment daily. Repair or replace worn or damaged parts immediately.
Do not exceed the maximum working pressure of the lowest rated system component. See the
Technical Data on page 18 for the maximum working pressure of this component.
Use fluids and solvents that are compatible with the equipment wetted parts. See the Technical
Data section of all equipment manuals. Read the fluid and solvent manufacturer's warnings.
Route hoses away from traffic areas, sharp edges, moving parts, and hot surfaces. Do not
expose Graco hoses to temperatures above 180 F (82 C) or below –40 F (–40 C).
Comply with all applicable local, state, and national fire, electrical, and safety regulations.
Do not point the dispense valve at anyone or at any part of the body.
Do not put your hand or fingers over the end of the dispense valve.
Do not stop or deflect leaks with your hand, body, glove, or rag.
Use only extensions and no-drip tips that are designed for use with your dispense valve.
Follow the Pressure Relief Procedure on page 4 before you clean, check, or service this
equipment.
Tighten all fluid connections before you operate this equipment.
Check the hoses, tubes, and couplings daily. Replace worn or damaged parts immediately. Do
not repair high pressure couplings; you must replace the entire hose.
Symbols
Warning Symbol
2
4
6
13
This symbol alerts you to the possibility of serious
14
injury or death if you do not follow the instructions.
16
17
Caution Symbol
18
18
20
20
This symbol alerts you to the possibility of damage to
or destruction of equipment if you do not follow the
instructions.