IHP FP4125-BDVI32 Installation Instructions

INSTALLATION INSTRUCTIONS FOR INSTALLING FULL FRONT FACADE KITS.
FOR USE WITH BELLEVUE™ AND DRI2032 GAS FIREPLACE INSERTS
KIT CONTENTS (See Figure 1)
1 ea. Full Front Facade Assembly
1 ea. Black Sheet Metal Screw
1 ea. Instruction Sheet
TOOLS NEEDED
Phillips Screwdriver
Full Front Facade Kits
f i r e - p a r t s . c o m
Cat. No. Model
F3133 FP4125-BDVI32 3 Sided Full Front Facade, 41" W x 25" H
F3134 FP4332-BDVI32 3 Sided Full Front Facade, 43" x 32"
GENERAL INFORMATION
If you encounter any problems, need clarifi cation of these instructions
or are not qualifi ed to properly install this kit, contact you local distribu-
tor or dealer.
Read this instruction sheet in its entirety before beginning the installation.
All of these parts may scratch and bend, great care should be used
in handling them.
ALL WARNINGS AND PRECAUTIONS IN THE INSTALLATION AND
OPERATION MANUAL PROVIDED WITH THE APPLIANCE APPLY TO
THESE INSTRUCTIONS.
TURN OFF THE APPLIANCE AND ALLOW IT TO COMPLETELY COOL
BEFORE PROCEEDING.
INSTALLATION INSTRUCTIONS
1. Position the appliance in the fi replace, but a few inches in front of its
fi nal location.
2. Using the screw provided, install the Control Assembly onto the left
side of the Full Front Facade (see Figure 1).
3. Hang the hooked brackets on the Full Front Facade into the openings
on the side mounting brackets on the appliance (see Figure 2).
NOTE: See Figure 3 on Page 2 for an illustration of the completed
installation.
P/N 900787-07
REV. A, 10/2016
Description
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE
MODELS BELLEVUE™ AND DRI2032
Control
Assembly
Figure 1 - Install Control Assembly onto Side of Full Front Facade
A
B
A
A = Openings where hooked brackets on Full Front Facade will hang.
B = Side Mounting Brackets on appliance
Figure 2 - Install Full Front Facade Onto Mounting Brackets
HEARTH PRODUCTS
KITS AND ACCESSORIES
FULL FRONT FACADE KITS
Full Front
Facade
Control
Install Screw
Assembly
A
B
A
1