Installing Controllers - Fast 973P Series Operator's Manual

4.6

INSTALLING CONTROLLERS

A chemical circuit sprayer control box, a boom
position switch box and foam marker toggle switch
should be mounted in the tractor cab.
1. Chemical Circuit Control Box:
The control box is equipped with a "U" bracket
secured by knobs on each end of the box. It
provides a universal mounting system adaptable
to any confi guration.
Use the two holes provided in the bracket to
mount to the box to a solid surface. Position the
box to face the operator and tighten the knobs
to hold the box in position.
Cut the power cable to the required length. Con-
nect the white wire to ground and the red wire
to a 12 volt battery or 12v power port. Refer to
Controller Manual. Panel fuse is a AGC-15 amp.
IMPORTANT
Do not connect across a 24 volt sys-
tem. It will damage internal electri-
cal components.
2. Boom Position Switch Box:
Mount the box next to the sprayer controller to
allow easy access. Connect to 12 volt power port.
Box fuse is a AGC-10 amp.
Plug the wiring harness from the 3 Point boom
into plug on pigtail that comes from boom posi-
tion switch box. Making sure to properly index
connector.
Fig. 13 CONTROLLER (TYPICAL)
Fig. 14 BOOM POSITION SWITCH BOX
23