Emerson Rosemount FCL Series Quick Start Manual page 14

Quick Start Guide
Figure 3-2: Alarm relay connections
A. Alarm relay 1
B. Alarm relay 2
C. Alarm relay 3
D. Alarm relay 4
1. To remove the cover, grab it by the upper edges and pull straight
out. The relay terminal strip is at the top of the board.
2. Bring the relay wires through the rear conduit opening on the left
hand side of the enclosure and make connections to the terminals
strip.
3. Replace the cover. The two tabs on the back edge of the cover fit into
slots at the rear of the enclosure, and the three small slots in the front
of the cover snap into the three tabs next to the relay terminal strip.
See
in place.
14
Figure 3-2. Once the tabs are lined up, push the cover to snap it
June 2019
Emerson.com/Rosemount