Checking The Protocol Firmware Version - Comtrol Device Master UP Hardware User's Manual

Checking the Protocol Firmware Version

DeviceMaster UP 16-Port Hardware User Guide: 2000596 Rev. B
11. Click Close to exit the Properties window.
12. If if applicable, check your firmware version to make sure that it is the latest
version using the next subsection,
13. If necessary, use Uploading Protocol-Specific Firmware on the DeviceMaster
UP on Page 20 to update or load the firmware for your DeviceMaster UP.
Use PortVision DX to check the firmware version before configuring the ports.
Depending on the model you purchased, the DeviceMaster UP may or may not
have the protocol firmware loaded.
Note: Models that have a protocol loaded on the DeviceMaster UP are identified in
PortVision DX and the DeviceMaster UP is labeled accordingly.
The following procedure shows how to use PortVision DX to check the firmware
version on the DeviceMaster UP and check for the latest files.
Note: If you have not done so, install PortVision DX
Page 12).
1. Start PortVision DX by double-clicking the PortVision DX desktop icon or click
Start > Programs > Comtrol > PortVision DX > PortVision DX.
2. Examine the List View pane to see if or/and what version of the firmware is
loaded on the DeviceMaster UP. If you see SocketServer or NS-Link as the
Software Version, you must load the appropriate firmware for your protocol.
3. Check the Comtrol FTP site to see if there is a later version available at:
ftp://ftp.comtrol.com/dev_mstr/up/software/modbus_router/firmware.
4. If applicable, download the latest version and go to
Protocol-Specific Firmware on the DeviceMaster UP
Configuring the DeviceMaster UP
Checking the Protocol Firmware
(Installing PortVision DX
Step 2
on Page 20.
Configuring the DeviceMaster UP - 19
Version.
on
in Uploading