Bracket And Rubber Pad Installation - Nakanishi E4000 CONTROLLER Operation Manual

10 . BRACKET AND RUBBER PAD INSTALLATION

10 - 1 Installation of the Brackets
CAUTION
・ If there is a possibility for the CONTROLLER from its mounting location, be sure to secure it with
the Provided Brackets for safety.
・ When mounting the Bracket, do not loosen any other screws other than the Mounting Screws
that are meant to install the Bracket.
・Brackets are provided 4pcs.
・Bracket Mounting Screws are attached to the following locations of the CONTROLLER (Fig. 9).
Bottom: 8pcs. Both sides: 4pcs. each side.
・The Bracket can be installed on the " (1) Bottom Mounting (Fig. 10, 11) " and " (2) Side Surface Mounting (Fig. 12,
13) " of the CONTROLLER.
Mounting Screw
Mounting Screw
Mounting Screw (8pcs.) attached to the bottom
of the CONTROLLER.
(1) Bottom Mountng
① Remove the Mounting Screws (8pcs.) from bottom of the CONTROLLER (Fig. 9).
② Install the Brackets (4pcs.) to the bottom of CONTROLLER by using removed Mounting Screws (8pcs.)
(Fig. 10).
③ Attach the CONTROLLER (Bracket's Slotted Area) to the machine using the mounting screws (8 pcs. not
included / provided by the end-user.) (Fig. 11).
* Mounting screws used to attach the CONTROLLER on the machine, not included / provided by the end-
user.
Mounting Screw
Bracket
Fig. 10
Mounting Screw
Mounting Screw (each 4pcs.) attached to the side of
the CONTROLLER.
Fig. 9
Mounting Screw
Mounting Screw 8pcs.
(Not included / Provided by
the end-user)
Slotted Area
Bracket
Fig. 11
63