Changing The Control Panel - Nakanishi E4000 CONTROLLER Operation Manual

14 . CHANGING THE CONTROL PANEL

WARNING
Make sure the input power supply is OFF before rotating the direction of setting Control Panel. If
the incoming power supply is ON, it may cause electric shock or damage to the CONTROLLER.
The position of the Control Panel can be changed from the front to rear of the CONTROLLER.
(1) Remove the 4 screws that af x the Control Panel and
pull the Control Panel gently from the CONTROLLER
(Fig. 20).
Remove the connector from rear of the Control Panel
(Fig. 20).
(2) Remove the screw from the Plate and pull the Plate
from the CONTROLLER (Fig. 21).
(3) Connect the connector inside the CONTROLLER to
the connector of the rear of the Control Panel.
(Fig. 22).
(4) Re-attach the Control Panel using the 4 mounting
screws (Fig. 22).
(5) Mounting the Plate using the 4 mounting screws.
(Fig. 23).
68
Remove
Pull
Plate
Mounting Screw
Connecting
Connector
Control Panel
Mounting Screw
Fig. 22
Conector
Pull
Control Panel
Mounting Screw
Remove
Fig. 20
Remove Remove
Fig. 21
Mounting
Mounting
Plate
Mounting Screw
Fig. 23