Self-Diagnosis - DeLonghi EX Series Instructions For Use Manual

INSERTING OR REPLACING THE BATTERIES
• Remove the cover on the rear of the remote control;
• Replace the old batteries with two new R03 "AAA" 1.5V bat-
teries, inserting them correctly (see the instructions inside
the battery compartment);
• Replace the cover.
If the remote control unit is replaced or discarded, the batteries
must be removed and disposed of in accordance with current
legislation as they are harmful to the environment. Do not mix
old and new batteries.
Do not mix alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium) batteries. Do not dispose of batteries in fire.
Batteries may explode or leak. If the remote control is not be
used for a certain length of time, remove the batteries.
Note:
• This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasona-
ble protection against harmful interference in a residential
installation.
• This equipment generates, uses and can radiate radio fre-
quency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee

SELF-DIAGNOSIS

The appliance has a self diagnosis system to identify a number of malfunctions.
Error messages are displayed on the appliance display.
IF THE FOLLOWING APPEARS ON
THE DISPLAY...
"Low Temperature"
... DO THE FOLLOWING
The appliance has a defrosting device
that prevents excessive ice build ups. The
appliance automatically starts operating
again once the defrosting process is com-
plete.
that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio
or television reception, which can be determined by turn-
ing the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
receiver.
- Connect the equipment into an outlet on a circuit differ-
ent from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician
for help.
Changes or modifications not expressly approved by the
party responsible for compliance could void the user's au-
thority to operate the equipment.
• This device complies with Part 15 of the FCC Rules. Oper-
ation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
• This Class B digital apparatus complies with Canadian ICES-
003.
IF THE FOLLOWING APPEARS ON
THE DISPLAY...
"High Level"
... DO THE FOLLOWING
Empty the inner water tray by following
the instructions in the paragraph "END OF
SEASON OPERATIONS".
If the error occurs again, please contact
our toll free customer service call center.
11
IF THE FOLLOWING APPEARS ON
THE DISPLAY...
"Probe Failure"
... DO THE FOLLOWING
If this appears, please contact our toll
free customer service call center.