Check Level Of Window Washer Liquid; Inspect Bucket Teeth And Side Cutters For Signs Of Wear - Doosan DX140R Operation & Maintenance Manual

NOTE: When refill or replace coolant, select "heater-full
hot" mode to fully open the water valve.
Coolant will then flow into the heater's core to
prevent air from being trapped in it.

Check Level of Window Washer Liquid

1. Open left rear access door and check fluid level in
windshield washer tank.
2. Open fill cap and add fluid.
NOTE: Use a washer liquid that is rated for all seasons.
This will prevent freezing during cold weather
operation.
Inspect Bucket Teeth and Side Cutters for
Signs of Wear
1. On a daily basis, inspect the bucket teeth to make sure that
tooth wear or breakage has not developed.
2. Do not allow the replaceable bucket teeth to wear down to
the point that bucket adapter is exposed. See Figure 33.
NOTE: These instructions are only for DOOSAN OEM
buckets. If you are using other manufacturers'
buckets, refer to their specific instructions.
Reference
Number
1
2
3
DX140R/DX140LCR
Description
Point
Adapter
Pin
Figure 31
Figure 32
Figure 33
Inspection, Maintenance and Adjustment
EX1502246
FG014424
4-23