Front Windows - Doosan DX140R Operation & Maintenance Manual

FRONT WINDOWS

AVOID DEATH OR SERIOUS INJURY
When leaving operator's seat, move safety lever to "LOCK"
position (Figure 138), if not a serious accident could occur
by accidentally moving work levers.
Front Upper Window
The front upper window can be housed in cabin's ceiling.
Opening the Window
AVOID DEATH OR SERIOUS INJURY
When stowing front window in cabin roof, make sure both
release levers (1, Figure 139) are latched.
1. Lower bucket or work tool to ground.
2. Move safety lever (Figure 138) to "LOCK" position.
3. Set engine speed control dial to "LOW IDLE". Allow engine
to idle for three - five minutes.
4. Stop engine by turning key to "O" (OFF) position.
5. Hold window handles (1, Figure 139), then pull lock levers
(2) to release lock. The top of front window will come out.
6. Pull window up, and push it against lock pin at rear of
cabin. Make sure that it is securely latched.
7. Check that lock levers are securely latched in lock position.
NOTE: When front upper window is open, never extend
your head or body through the window frame.
NOTE: If window happens to fall with a strong impact
against machine, while some part of your body
is extended out of cabin, it can result in bodily
injury.
DX140R/DX140LCR
WARNING
WARNING
Unlock
Lock
Figure 138
2
1
Figure 139
EX1300566
FG014391
Operating Controls
2-61