Multifunction Gauge And Graphic Information - Doosan DX140R Operation & Maintenance Manual

Hide thumbs Also See for DX140R:
Table of Contents

Advertisement

MULTIFUNCTION GAUGE AND
GRAPHIC INFORMATION
When the engine starter switch is turned to "I" (ON) position, a
LOGO will appear on the display screen for about two seconds.
When the LOGO disappears, the multifunction gauge and
graphic information screen will appear.
The engine rpm is normally displayed at the bottom of the
screen when the starter switch is first turned "ON". Each time the
display selector button (19, Figure 36) is pressed, the digital
readout changes in the following sequence; Engine speed (rpm)
-> Battery voltage (VOLT) -> Front pump pressure (BAR) ->
Rear pump pressure (BAR).
NOTE:
See Figure 53 thru Figure 56.
A digital clock is located at the top of the display.
By using a combination of the mode selector buttons,
information for filters and oils can also be displayed.
The display can also be set for the desired language.
Refer to the "Setting Main Menu" on page 2-33 for the language
selection and information display sequences.
Communication Indicator
Indicates the condition of communication between main
controller and instrument panel.
1.
Normal Condition:
The symbol will sequentially move like lightening.
NOTE:
See Figure 53 thru Figure 56.
2.
Abnormal Condition:
If the symbol is not displayed, it means there is a
communication error.
NOTE:
See Figure 52.
DX140R/DX140LCR
E
C
H
Figure 50
Figure 51
F
C
H
FG013591
FG000047
Operating Controls
2-25

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dx140lcr

Table of Contents