Add New Feature; Notes Concerning Use Of “Update” And “Add New Feature” - Denon AVR-X6700H Owner's Manual

Contents Connections
o Add New Feature
Display new features that can be downloaded to this unit and perform
an upgrade.
Upgrade Package:
Upgrade Status:
Upgrade:
0 Information regarding the "Update" function and "Add New Feature" will be
announced on the Denon website each time related plans are defined. See
the Denon website for details about upgrades.
0 When the procedure is complete, "Registered" is displayed in this menu and
upgrades can be carried out. If the procedure has not been carried out, "Not
Registered" is displayed.
The ID number shown on this screen is needed when carrying out the
procedure.
The ID number can also be displayed by pressing and holding the main unit's
u and INFO for at least 3 seconds.
0 If the upgrade is not successful, "Upgrade Error" message appears in the
display. See "Troubleshooting" – "Update/upgrade error messages" for
information on upgrade error messages. (v p. 316)
Check the settings and network environment and then perform the upgrade
again.
0 This menu cannot be selected when "Allow Update" is set to "Off".
Front panel Display
Playback
Display the items to be upgraded.
Display a list of the additional functions
provided by the upgrade.
Execute the upgrade process.
When the upgrade starts, the menu
screen is shut down. During the upgrade,
the amount of upgrade time which has
elapsed is displayed.
Rear panel
Settings
Notes concerning use of "Update" and "Add New Feature"
In order to use these functions, you must have the correct system
0
requirements and settings for an Internet connection. (v p. 94)
Do not turn off the power until updating or upgrading is completed.
0
Approximately 1 hour is required for the updating/upgrading procedure
0
to be completed.
Once updating/upgrade starts, normal operations on this unit cannot
0
be performed until updating/upgrading is completed. Furthermore,
there may be cases where backup data is reset for the parameters,
etc., set on this unit.
If the update or upgrade fails, press and hold the X on the main unit for
0
more than 5 seconds, or remove and re-insert the power cord. After
about 1 minute, "Please wait" appears on the display and update
restarts. If the error continues, check the network environment.
280
Remote
Tips Appendix
Index