Hdmi Audio (Zone2 Only); Volume Level; Volume Limit; Power On Volume - Denon AVR-X6700H Owner's Manual

Contents Connections
o HDMI Audio (ZONE2 only)
Selects the audio signal format for playing an HDMI source in ZONE2.
Through
(Default):
PCM:
o Volume Level
Set the volume output level.
Variable
(Default):
1 – 98
(–79 dB – 18 dB):
0 The dB value is displayed when the "Scale" setting is " –79.5 dB – 18.0 dB".
(v p. 200)
Front panel Display
Playback
The HDMI audio signal is passed through
this unit to the device in ZONE2.
The HDMI audio signal input into this unit
is converted to a PCM signal that can be
output from the ZONE2 PRE OUT
connectors or speaker terminals.
Volume can be adjusted.
Volume is fixed at the desired level. The
volume cannot be adjusting using the
remote control unit.
Rear panel
Settings
o Volume Limit
Make a setting for maximum volume.
60 – 80 (–20 dB – 0 dB)
(Default : 70 (-10 dB))
Off:
0 This can be set when "Volume Level" is set to "Variable". (v p. 275)
0 The dB value is displayed when the "Scale" setting is " –79.5 dB – 18.0 dB".
(v p. 200)
o Power On Volume
Define the volume setting that is active when the power is turned on.
Last
(Default):
Mute:
1 – 98
(–79 dB – 18 dB):
0 This can be set when "Volume Level" is set to "Variable". (v p. 275)
0 The dB value is displayed when the "Scale" setting is " –79.5 dB – 18.0 dB".
(v p. 200)
275
Remote
Tips Appendix
Do not set a maximum volume.
Use the memorized setting from the last
session.
Always mute when power is turned on.
The volume is adjusted to the set level.
Index