Page 1
Replacing The FoRwaRd RiseR sTep 1 sTep 2 Place handle into the most forward position near the Forward Remove the handle rest bolts. Riser Pulley. sTep 3 sTep 4 Pivot back the footboard. Remove the cover from the rower to expose the top deck. sTep 5 Remove the handle.
Page 2
Replacing The FoRwaRd RiseR sTep 5 conT. Remove the handle, (Continued); b. Using a 1/8 allen key, remove the bolt joining the handle to the clutch. c. Pull the handle free from the clutch. sTep 6 Using the 5mm ratchet supplied with the machine, remove the bolts and washers (2 on either side) joining the Font End Pad to each rail.
Page 3
Replacing The FoRwaRd RiseR sTep 8 sTep 9 Remove the Forward Riser Assembly Replace with the new Forward Riser Assembly sTep 10 To secure the replacement Forward Riser in place, screw back in the 4 bolts and washers securing the Front End pad to each rail. We recommend leaving these slightly loose in case any adjustment is needed when securing the tie rods.
Page 4
Replacing The FoRwaRd RiseR sTep 12a sTep 12b sTep 12c sTep 12d Replace the handle, to do this (please see this link to a video on replacing the handle); a. Ensure the handle is the correct way around before threading the strap through the end cap and over the Forward Riser Pulley.
Page 5
Replacing The FoRwaRd RiseR sTep 13 Ensure the recoil belt is straight and aligned over the 2 guide pulleys on the Forward Riser. Reconnect the bungee cord to the recoil belt. sTep 14 Replace the tank cover plate. sTep 15 Swing the footboard back into position towards the tank and replace the handle rests and bolts.