WaterRower S4 Wood Assembly Manual

Table of Contents

Download this manual

S4 Wood Assembly Manual

INTRODUCTION

We have all experienced the frustrations caused by incomprehensible Assembly Instructions. For this reason, we

have gone to added lengths to make our instructions as clear and concise as possible. Do not be intimidated by the

detail; it is simply intended to make the assembly process as comfortable as possible for you.

Your WaterRower comes partially dis-assembled in two boxes for protection during shipment.

Assembling your WaterRower should take no more than half an hour, all you require is a 5mm Allen Key which is

attached to the Rear Spacer.

Lay the Rails on the floor and connect the Rear Spacer using the male JCN Nuts and the Allen Key provided.

Position rails with black extrusions on the inside.

Rear Spacer

Allen Key

Male JCN

Sit the Seat between the Rails. Note the orientation of the Seat with the indent facing the rear. It may be necessary to

separate the Rails slightly to allow the seat to sit into place.

Place the Tank Assembly between the Rails.

WaterRower.com

Table of Contents

Do you have a question about the S4 Wood and is the answer not in the manual?

Page 1 Your WaterRower comes partially dis-assembled in two boxes for protection during shipment. Assembling your WaterRower should take no more than half an hour, all you require is a 5mm Allen Key which is attached to the Rear Spacer.
Page 2 Press the Heelrest Adjustment Button (A) and insert the Heelrest/Footpads under the Footboard Cover Plate (B). Release the button to ‘lock’ the Heelrests rests into place. You can adjust the height of the Heelrests according to your foot size (refer to page 2/3 of the Owner’s Manual). WaterRower.com...
Page 3 STEP TEN Lay the WaterRower down and using the Syphon Pump provided (or a hose if available) fill the Tank to the desired level (See Water Level section in the Owner’s Manual) with Chlorinated Town or Municipal Water. Do not over fill your WaterRower.