Lcd Initial Setting; Setting The Clock - Kubota M7-132 Operator's Manual

LIQUID CRYSTAL DISPLAY (LCD)

1. LCD initial setting

WARNING
To avoid personal injury or death:
Take the following precautions when starting initial
setting.
• Park the machine on firm and level ground.
• Set the parking brake.
• Lower the implement to the ground.
Before operation, make sure the clock and the working
range of implement are set.
Once registered, the working range of an implement is
put in memory. When the implement is changed to a
different one, the latter's working range must be
entered anew.
Otherwise, the work area and other data will not be
correctly displayed.

1.1 Setting the clock

1. Turn on the key switch.
2. Press the [SET UP/00] switch, and the setting
mode screen appears on the liquid crystal display
(LCD) unit.
(1) [SET UP/00] switch
(2) [Select] switch
(3) [ENT] switch
(4) [ESC] switch
M7-132,M7-152,M7-172
INTELLIPANEL
(1) Clock setting
(2) Clock display ON/OFF setting
(3) Working range of implement
3. When the "Clock setting" has been selected with
the [Select] switch and then the [ENT] switch
pressed, the clock setting screen shows up.
(1) Hour
(2) Minute
(3) Set switch
4. Setting the "Hour" of the clock:
a. Select with the [Select] switch and then
press the [ENT] switch to choose the "Hour"
(highlighted).
b. To put the clock forward, select
[Select] switch and then press the [ENT]
switch. The hour continues to change if the
[ENT] switch is held down.
c. To put the clock back, select
switch and then press the [ENT] switch. The
hour continues to change if the [ENT] switch is
held down.
™
CONTROL
with the
with the [Select]
49