Table of Contents
Advertisement
OPERATING THE TRACTOR
1. Programming the headland
management system
To utilize the headland management system, it must be
preprogrammed.
Details regarding the initial entries and modifications for
the program can be found in a different section.
(See Setting the headland management system on
page 88.)
2. Loading a program to the program
code
By selecting 2 types of programs that are frequently
used within a loaded program and loading to the
program codes ( ,
, ',
executed simply by touching the field out button or field
in button.
For details on loading a program to a program code,
refer to the section Setting the headland management
system on page 88.
(1) Program codes
(2) Work name and implement name entered when the program
was loaded
3. Handling the headland
management system
1. Get the engine started and touch the right half of
the headland management system lock and unlock
switch to unlock the system. Once unlocked, the
headland management system lock indicator goes
off.
2. Using the program select switch, choose the
program code ( or ').
3. When the headland has been reached, press the
field out button. The recorded program will be
carried on. After swiveling the machine, press the
field in button.
168
'), the programs can be
HEADLAND MANAGEMENT SYSTEM
4. To interrupt the program execution, press the field
out or field in button, for which the indicator stays
on.
(1) Headland management system lock indicator
(2) Program code display indicator
(3) Headland management system lock and unlock switch
(4) Program select switch
NOTE :
• The headland management system is kept
locked all the time when the engine gets
started. To enable this system, press the
headland management system lock and unlock
switch to unlock it.
• While the program is being executed, the
manually operated levers and switches can be
used. If the opposite operation takes place
while the program is running, however, the
program run is interrupted.
For example, the program is interrupted if the 3-
point quick lower switch is used and then the 3-
point quick raise switch is pressed.
• Before turning on the PTO shaft, use the PTO
gear shift lever to select the PTO shaft speed
(540 or 1000 rpm) in advance.
• Before using the remote control valves, set the
remote control valve switch to the "NEUTRAL"
position.
• Work can also be started, pressing the field in
button as the first step.
Field in and out buttons
When the indicators of both buttons are on, press either
of the buttons to activate the headland management
system.
M7-132,M7-152,M7-172
Advertisement
Table of Contents
