Table of Contents
Advertisement
LIQUID CRYSTAL DISPLAY (LCD)
(1) Distance measuring
How to measure distance
1. Press the [Select] switch to select the distance
measurement icon on the meter panel (highlighted).
In that state, press and hold the [ENT] switch to
enable distance measurement.
2. Press
the
[ENT]
measurement. Press the [ENT] switch again to stop
distance measurement.
(1) "Distance measurement stopped"
(2) "Measurement distance"
3. To reset the measured value to zero, press and
hold the [SET UP/00] switch while distance
measurement is enabled.
4. Press [ESC] switch to return to the normal screen
and stop distance measurement. Also, after
stopping distance measurement, the measured
value can be reset to zero by holding down the
[SET
UP/00]
switch
measurement icon on the performance monitor in
the meter panel is selected.
M7-132,M7-152,M7-172
switch
to
start
distance
while
the
distance
™
INTELLIPANEL
CONTROL
59
Advertisement
Table of Contents
