Invacare AVIVA RX Series Service Manual page 66

Invacare® AVIVA™ RX series
1. Unplug all cables from the electronic modules which
run from seat to chassis.
2. Loosen and remove screws A and washers B on both
sides.
3. Remove seat including brackets C from chassis.
4. Place seat on wooden blocks.
5. Loosen and remove screws D on both sides.
6. Replace brackets C on both sides.
7. Re-install screws. Tighten screws.
8. Place seat including brackets on chassis.
9. Change position of seat according to required seat
depth. See 4.3 Adjusting Centre of Gravity — Ultra Low
Maxx Seat, page 9 .
10. Install screws A and washers B. Tighten screws.
11. Plug in all cables.
12. Test all functions.
66
Fig. 6-59
Fig. 6-60
1654647-A