Advertisement
MIDI is a large format series of aluminum casing, electric projection screens. Timeless design and a wide
selection of projection surfaces makes it the most frequently selected screen for installation in assembly
halls, lecture rooms and large conference and halls and auditoriums.
1. The screen's lower casing and bar are protected against damage using a polyurethane foam and tapes.
The foam and tapes which secure the casing should be removed only at step no. 4, while the foam which
secures the lower bar only at step no. 6 of these instructions.
2. The screen should be mounted in a place away from moisture and intense sunlight.
3. To clean the product, use a soft, damp cloth. Do not use active detergents. Do not allow for water and
other fluids to get inside the device. After cleaning, the screen should be carefully wiped, removing any
remaining moisture.
4. A correctly mounted screen must be absolutely level in every plane.
5. No more than one control switch can be connected to the screen/lift at one time.
6. One control switch (e.g. RC01/RC02/Trigger 12V/Trigger 230V/IR Receiver/RS Receiver, etc.) cannot
be connected to more than one device, like a screen, lift, roller-blind, etc., at a time.
Switch
Projection screen
Mounting holder
Mounting angle bracket
Ø14 anchor plug for wall mounting
M6x12 screw
M6 washer
L-shaped screen locking and securing bar
Screen hanging chain
Key for screen end position adjustment
Wall-mounted pushbutton switch (available with screens without built in radio
control)
IMPORTANT!!!
REMARKS ON INSTALLATION AND USE
Screen/lift
Switch
motor
Package contents:
w
w
w .
k
Screen/lift
motor
a
u
b
e
r .
-3-
Controller
Quantity
e
u
Screen/lift
motor
1 pcs.
3 pcs.
3 pcs.
12 pcs.
12 pcs.
12 pcs.
6 pcs.
2 pcs.
1 pcs.
1 pcs.
Advertisement
