Table of Contents
Advertisement
Chengdu Ebyte Electronic Technology Co,;Ltd
5.6.3 Configuration procedure of module
Only happened when power-on resetting or exiting sleep mode
6. Operating Mode
The table below shows the status of corresponding modes: •
Mode (0-7)
0 RSSI mode
1 Continuous mode
2 Sub-package mode
3 Configuration mode
4 WOR mode
5 Configuration mode
(Same as M ode 3)
6 Power saving mode
Chengdu Ebyte Electronic Technology Co,;Ltd
Copyright ©2012–2019，
M2
M1
M0
UART opens. Wireless closes and
0
0
0
transmission is unavailable.
UART opens. Wireless closes and
0
0
1
continuous transparent transmission is
available.
UART opens. Wireless closes and sub-
0
1
0
package transparent transmission is
available.
UART opens. Wireless closes and
0
1
1
parameter can be configured.
UART opens. Wireless closes and sub-
1
0
0
package transparent transmission is
available.
1
0
1
-
UART closes. Wireless works at WOR
1
1
0
power saving mode. M ultiple time
grades can be configured.
Mode introduction
E70-868T14S2 user manual
Remark
M odule outputs RSSI value each 100ms
through UART
Air
data
rate
can
be
automatically according to baud rate.
The baud rate must be same on both
receiver and transmitter. It is applicable
for
high
speed
continuous
transmission.
Air data rate and baud rate can be
adjusted separately. It is applicable for
data packet transmission.
Baud rate is fixed as 9600 8N1.
Receiving is not available under this
mode. Preamble code will be added
proactively before transmission to wake
up the receiver under mode 6.
-
Transmission is not available under this
mode. It can be woken up by transmitter
under mode 4 to achieve low power
consumption receiving.
adjusted
data
10
Advertisement
Table of Contents
