Configuration Mode (Mode 3); Wake-Up Mode (Mode 4) - Ebyte E70-868T14S2 User Manual

Chengdu Ebyte Electronic Technology Co,;Ltd
Baud rate & Under this mode, the baud rate and air data rate are independent, both receiver and transmitter can have different
air data rate baud rate but same air data rate.
Very low air data rate can be configured for longer distance, the data continuousness between output data depends
Advantage
on the data packet length.
Since the air data rate is low and the receiver needs to wait for the data packet length or timeout byte numbers, it
Disadvantage
may cause some delay, which depends on the actual value as set.
Applications Applicable for those applications requiring distance and continuous data while not requiring transmission speed.
1. Air data rate and baud rate are not relative; the values are valid.
2. 0000 and FFFF are the broadcast addresses, which can be used to monitor and broadcast.
Note 3. The addresses and air data rates must be same, but baud rates can be different on both receiver and transmitter.
4. The size of individual data packet depends on the subpackage size CHAN [7:5] (excluding address and channel
for directional transmission)

6.5 Configuration Mode (Mode 3)

Status M0=1 M1=1 M2=0
Transmitting Transmission not available, serial data received will be discarded.
Receiving Receiving is not available.
Configuring Parameter configuration can be made in configuration mode with specific instruction format and UART 9600, 8N1.
When entering other modes from configuration mode, the module will reconfigure parameters, AUX keep s low level
Note during configuration;
After configuration completed, it outputs high level, so users are recommended to check the AUX rising edge.

6.6 Wake-up Mode (Mode 4)

Status
Transmitting
Receiving
Baud rate & air
data rate
Advantage
Disadvantage
Applications
Chengdu Ebyte Electronic Technology Co,;Ltd
Copyright ©2012–2019，
M0=0 M1=0 M2=1
Transmission is available.
Receiving is not available.
Under this mode, the baud rate and air data rate are independent, both receiver and transmitter can have different
baud rate but same air data rate.
It can wake up the receiver under mode 6; wake up code will be added automatically before transmitting, the
code number depends on the wake up time.
The transmission time is long, only applicable to wake up the receiver, not applicable for common data
transmission.
For waking up the receiver under WOR mode.
E70-868T14S2 user manual
13