NEC Versa LX Manual page 8

Slide the drive connector back into the cradle pack connector. Press down on both sides of
3.
the lever to lock the drive into place. Secure the drive to the cradle with the screw.
4. The cradle with the hard disk drive is ready to be inserted into the system's VersaBay III
slot.
Launching the Copy Utility
Make sure that the CD-ROM drive and the new hard disk drive are installed in your NEC Versa
notebook. Insert the NEC Hard Drive Upgrade Setup CD into the drive and power on the
system. Use the following steps to run the Copy utility.
Note
To confirm you have the hard disk drives in the correct locations, attempt to boot the
system. If the system boots, the original hard disk drive is not in the cradle. Do not use the Copy
utility with the original drive in the system's internal drive bay.
1. When the system boots, a message appears stating that the internal drive contents will be
lost. Press
Drive Image creates a small temporary partition on drive C where the data transfer files are
copied.
2. A message appears telling you to remove the CD from the drive, remove any diskettes, and
power off the system. Once you power off the system, remove the CD-ROM drive and
insert the VersaBay III cradle with the original disk drive installed into the system. Power
on the system.
The system boots and the PowerQuest DriveCopy main screen appears. Select "Entire Disk
3.
Copy." Verify that the source drive is Drive 2 and the destination drive is Drive 1. Select
"Finish."
4. A warning message appears telling you that the contents of drive 2, VersaBay III drive,
replaces the contents of drive 1, internal drive. Click Yes.
The DriveCopy program copies the data to the new internal drive. The process takes
approximately 10 to 30 minutes depending on the amount of data to be copied.
8 NEC Versa LX and LXi Hard Disk Drive Upgrade Kit
Securing the drive
A — Hard Disk Drive Lever
to proceed. Press to quit.
R Q
B — Screw