NEC Versa LX Manual page 5

not squeeze the drive by the top and bottom. Do not push on the top and bottom of the drive.
To eliminate static discharge, touch a grounded metal object while handling the hard disk drive.
Note
Using a small sticker, label the original drive to avoid confusion later. Place the sticker
on the same side as the caution label and mark the drive "original."
Removing the Drive in the Cradle Pack
Use the following procedure to remove the hard disk drive from the cradle pack.
1. Place the cradle pack with the securing screw facing up.
Remove the securing screw. Place your finger in the center notch of the hard drive lever and
2.
pull up the lever. Be sure that both sides of the lever are raised.
3. With the lever raised, place your fingers on the inside edge of the lever and on each side of
the center notch. Pull the drive away from the drive connector. Lift the drive out of the
cradle.
Use care when handling the hard disk drive. Hold it from the sides; do
Lifting the drive out of the bay
Removing the drive
A — Hard Disk Drive Lever
NEC Versa LX and LXi Hard Disk Drive Upgrade Kit 5
B — Screw