Load Cell Connections; Connect Adaptor And Charging - T Scale RWP Technical Manual

RWP Weighing Indicator Technical Manual(v1.16)
 Warm-up time of 15 minutes stabilizes the measured values after
switching on.
 Calibrate with exact calibration weights, minimum 1/3 of the scale capacity
want to use for calibration. For calibration see details in parameter.
Then you can start your operation

Load cell connections





Connect Adaptor and Charging

 To charge the battery insert the adaptor pin to jack. Adaptor simply plug into
the mains power. The scale no needs to be turned on.
 The battery should be charged 12 hours for full capacity.
 The symbol status of the battery
Battery voltage has dropped
Low voltage
Fully charged
.
 Do not use any other type of power adaptor than the one supplied with the
scale.
 Verify that the AC power socket outlet is properly protected.
Note: Please charge the battery before using the scale for the first time.
Connect the load cell cables to the terminal as shown below.
5Pin
Connection
Pin 1 Signal +
Pin 2 Signal -
Pin 3 Shield
Pin 4 Exc -
Pin 5 Exc +
It can connect four 350 ohm load cells.
The load cell drive voltage is 5V DC ±5% between
Excitation + and Excitation -.
- 8 -