Instalation; Unpacking; Installation - T Scale RWP Technical Manual

RWP Weighing Indicator Technical Manual(v1.16)

Unpacking

When you receive the scale, inspect it to make sure that it is not damaged and
that all are parts are included:
 Remove the Indicator from the carton.
 Remove the protective covering. Store the packaging and to use if you
need to transport the scale later.
 Inspect the indicator for damage.
 Make sure all components are included.
1. Indicator
2. Adaptor
3. Manual
4. Indicator holder (Optional)
5. Load cell Output connecter (Optional)
6. RS-232 Output Connecter (Optional)

Installation

 Place the Indicator on a table or connect with proper stand.
 Connect the plat form load cell cable in to the indicator load cell connecter.
Load cell connecter is locating back side of the indicator.
 Connect the adaptor pin in to the indicator adaptor jack.
Adaptor jack is locating, back side of the indicator.
 Adaptor connects into your AC power socket.
Pluggable equipment must be installed near an easily accessible socket
outlet with a protective ground/ earth contact.
 Turn on the On/Off key. If you want to turn off, press the key again.
 Display will be show the scale capacity and will be starting self-checking.
 After self-checking, display will be come to normal weighing mode.
3. INSTALLATION
RS-232 port
Bracket
Load cell connecter
Adaptor jack
- 7 -