Accumulation - T Scale RWP Technical Manual

RWP Weighing Indicator Technical Manual(v1.16)
Press key to enter, press
Press key to enter, press
Select desired setting by pressing
press key to escape.
Note: The load weight must greater than 20 scale divisions for the check
weighing operations.
To disable the check weighing function, enter zero into both limits.

5.9. Accumulation

To enable accumulation function, select parameter F5 ACC > ACC on
 Place the goods on the platform to be weigh
Wait few seconds for display stable, then press
be saved and printed (if the printer is connected).
Display will be appear
this display will appear two seconds only.
Remove the load and wait few seconds for display return to zero.
 Place the second goods on the platform.
Wait few seconds for display stable. Then press
be saved.
Followed by the total number of weight will be displayed
It can continue the process until the maximum capacity or value.
key until display show
Check mode 1
Check mode 2
Check mode 3
key and press
ACC 1
bEEP
bP 1
bP 2
bP 3
key to confirm,
key. The value will
key . The value will
ACC 2
- 13 -