9 March 2004
3.7 TONER SUPPLY CLUTCH
1. Toner bottle holder
2. Copy tray (☛ 3.3.3)
3. Rear cover (☛ 3.3.2)
4. Disconnect the connector on C19
on the BICU.
5. Push the clutch coupler [A] to the
rear side, and remove the clip
ring [B] from the back of the
copier.
6. Coupler and spring [C]
7. Lift the toner supply clutch [D]
and remove it.
NOTE: When removing, note how the wire goes through a clamp, and also
note where it passes through the rear of the machine.
3.8 HIGH-VOLTAGE POWER SUPPLY BOARD
1. Rear cover (☛ 3.3.2)
2. High-voltage power supply board [A]
(all "'s, ! × 4)
NOTE: Remove the insulating sheet [B] if you are going to remove the contact-
release solenoid (☛ 3.5.9) or the gear cover (☛ 3.10.7).
[D]
[A]
[B]
[B]
[A]
3-21
TONER SUPPLY CLUTCH
[C]
B130R954.WMF
B130R924.WMF