Tight The Roof Cover - Producer's PRIDE 1339494 Assembly Instruction Manual

ASSEMBLY
STEP 13: Tight the roof cover.
Connect 1pc 15# tube with 2pcs #16 tube, and then insert it into the bottom sleeve of the roof tarp.
Meanwhile, tie the web strap 31# over the tube and then fix the Ratchet Tie Down 29# onto it as
shown in below drawings and pull tight.
Insert the "S"-hook on hook on ratchet into hole on the leg. Wind the ratchet so
that the webbing overlaps itself.
Next, install Anchors (Part # 26, #27 & #28) at the 4 Corner by screwing the
removable anchor (#26) into the ground. Secure with Cable (#27) and Cabl
Clamp(#28) as shown in the right Diagram. Suggest assemble the Anchors
inside the Run.
Now the Run is ready for use!
16
16
15
10
press
31
fig.1 fig.2
31
29
fig.3
27
28
26