Tighten The Front & Back Fabric Panels; Roof Cover Assembly - Producer's PRIDE 1339494 Assembly Instruction Manual

ASSEMBLY
STEP 11: Tighten the front & back fabric panels.
Insert the tube 15# into the bottom sleeve of the panels as shown in below Fig.1. Then tie the
puller strap 30# over the tube 15# shown in Fig.2, pull tight as shown in Fig.3.
Note: When installing the back door tarp, connect 15# and 16# first, and then insert it into the
sleeve sewn on bottom of the fabric.
20
15
STEP 12: Roof cover assembly.
Lay the cover on the ground next to the
frame with inside of the cover facing up
with the webbing on the front and rear
of the corner of the building. Pull cover
over the frame by the help of the rope,
making sure to center cover on frame.
There should be an equal amount
of overhanging at all four corners.
21
16
15
15
16
9
press
15
Fig.1
30
Fig.2
The Webbing
Roof Trap
30
Fig.3