In order to verify, you may access the bridged AP configuration, then under Status, the option "Client
Bridge Mode" would be set to Isolated like shown on the figure down below:
Important Notes :
•
The access point that will be operating on bridge mode, must be set with a fixed IP address before
activating the bridge mode on the access point.
•
Users must enable client bridge support option under SSID or SSID Wi-Fi settings in order to have
it fully functional. See [Client Bridge Support]
Figure 44: Client Bridge
Figure 45: Client Bridge
Figure 46: Client Bridge Mode
GWN76XX User Manual
Version 1.0.15.x
P a g e
|
60