Leckey Mygo+ User Manual page 18

p18 Leckey Mygo+ User Manual
SECTION 7.14:
ATTACHING THE
HIP LATERALS
Hip laterals are used with the Pelvic
Cradle. First, remove the Pelvic Harness
brackets if required, by removing the
screw and flange nut
of polypropylene on the front of the sacral
support. Place the hip lateral brackets into
the slots and attach using the flange nuts
and screws
B C
nuts should go on the front side
of the sacral support.
A
. Lift the piece
A
provided. The flange
SECTION 7.15:
RETROFITTING THE
DYNAMIC BACKREST
To replace the standard static backrest
with the dynamic backrest first of all you
will need to remove the screw
top of the standard backrest assembly.
To do this loosen the nut using the Leckey
tool and a 10mm spanner and remove the
screw and washers.
Again using the Leckey tool and the
10mm spanner, loosen the nut
bottom of the standard backrest assembly
then remove screw saddle washers and
standard washers.
Use caution when Use caution when
assembling and fitting assembling and fitting
the dynamic backrest the dynamic backrest
as there is a minor risk as there is a minor risk
of finger nipping. of finger nipping.
at the
A
at the
B
A
B